Cascade Card Tutorial

Tuesday is here again and for today’s post I have a Cascade Card Tutorial.  I originally saw this tutorial on Beccy’s Place.  It is a rather unique shape and does make a rather nice card if you are looking for something different.

Outside of Card

tutorial_card_outside

Inside of Card

tutorial_card_inside

Supplies used:

Step 1:  Take a 12″ x 12″ piece of cardstock and cut it to be 6″ x 12″.

tutorial_step_1
Step 2:  Starting from the left hand side and on the long side score at 2″, 4″, 8″ and 10″.  Fold in along the scorelines as mountain, valley, valley and mountain.

tutorial_step_2
Step 3:  Measure 2″ down from the top left hand corner of the card.  Draw a line from the mark that was just made to the top of the 4″ score line.  Do the same on the right hand side using the top of the 8″ scoreline.  Cut along both of these lines.  Keep both pieces.

tutorial_step_3

tutorial_step_3a

Step 4:  Design Paper Preparation.  Whatever design paper you decide to use, cut 1 piece to be 5 3/4″ x 3 3/4″.  This is to be used for the inside middle part of the card.  Cut 4 pieces of paper to be 5 3/4″ x 1 3/4″.  Use the triangular off cuts to get the correct angles for the strips and make sure that you trim the panels in the right direction

tutorial_step_4

tutorial_step_5

The image Penquin Love, was coloured with Copic Markers.  Polar White Flower Soft was used on the trim of the hats.  The image was then fuzzy cut and mounted to the middle panel.  The sentiment was added to the left front panel.  Faux Snow was also added to the middle panel.

For any supplies that you have on your wish list for Santa, do check out Lora’s OCS store for some amazing products and prices.

Until next time, keep crafting.

Hugs,

SueBerkley_w

Leave a Reply

Your email address will not be published. Required fields are marked *